Removal Procedure
- Disconnect the ignition coil connectors from the ignition coils.
- Remove the retaining bolts from the ignition coils.
- Remove the ignition coils from the engine.
Installation Procedure
Important: Make sure that the ignition coil seals are properly seated to the valve cover.
- Install the ignition coil.
Notice: Refer to Fastener Notice in the Preface section.
- Install the ignition coil retaining bolts.
Tighten
Tighten the ignition coil retaining bolts to 10 N·m (89 lb in).
- Replace the ignition coil connectors.