Tools Required
SA9127E
Gage Bar Set, or
J 34730-1A
Fuel Pressure Gage
Caution: Refer to Gasoline/Gasoline Vapors Caution in the Preface section.
Caution: Remove the fuel tank cap and relieve the fuel system pressure before
servicing the fuel system in order to reduce the risk of personal injury.
After you relieve the fuel system pressure, a small amount of fuel may be
released when servicing the fuel lines, the fuel injection pump, or the connections.
In order to reduce the risk of personal injury, cover the fuel system components
with a shop towel before disconnection. This will catch any fuel that may
leak out. Place the towel in an approved container when the disconnection
is complete.
- Turn the ignition OFF.
- Disconnect the negative battery cable. Refer to
Battery Negative Cable Disconnection and Connection
.
- Loosen the fuel fill cap to relieve the fuel tank vapor pressure.
- Remove the intake manifold cover. Refer to
Intake Manifold Cover Replacement
.
- Remove the cap from the fuel pressure service port.
- Connect the
SA9127E
, or the
J 34730-1A
to the fuel
pressure service port connection. Wrap a shop towel around the port while connecting the gauge in order to avoid spillage. Refer to
Fuel Pressure Gage Installation and Removal
.
Caution: Do not drain the fuel into an open container. Never store the fuel in
an open container due to the possibility of a fire or an explosion.
- Install the bleed hose of the
SA9127E
, or the
J 34730-1A
into an approved fuel container.
- Open the bleed valve on the
SA9127E
, or the
J 34730-1A
in order to bleed the fuel system pressure. The fuel connections are now safe for servicing.
- Place a shop towel under the fuel pressure service port to catch any remaining fuel spillage.
- Disconnect the
SA9127E
, or the
J 34730-1A
from the fuel pressure service port connection. Refer to
Fuel Pressure Gage Installation and Removal
.
- Drain any fuel remaining in the gauge into an approved fuel container.
- Install the cap to the fuel pressure service port.