For 1990-2009 cars only
Removal Procedure
- Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
- Disconnect the evaporative emission (EVAP) line from the EVAP purge solenoid valve. Refer to Plastic Collar Quick Connect Fitting Service .
- Cap or plug the EVAP line and the purge solenoid in order to prevent system contamination.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the evaporative emission (EVAP) canister. Refer to Evaporative Emission Canister Replacement .
- Remove the rear brake pipe bracket nuts and release the brackets from the body studs.
- Release the pipe retainers (1) from the vehicle underbody.
- Remove the EVAP purge line from the pipe retainers.
- Lower the rear of the line while moving the line rearward slightly, then lower the front of the line.
- Remove the EVAP purge line from the vehicle.
Installation Procedure
- Position the EVAP purge line to the vehicle.
- With the rear of the line positioned slightly rearward and down, raise the front of the line into position.
- Install the remainder of the line into position.
- Install the EVAP purge line to the pipe retainers.
- Secure the pipe retainers (1) to the vehicle underbody.
- Install the rear brake hose brackets to the body studs and install the rear brake hose bracket nuts.
- Install the EVAP canister. Refer to Evaporative Emission Canister Replacement .
- Lower the vehicle.
- Remove the caps or plugs from the EVAP line and the purge solenoid.
- Connect the EVAP line to the EVAP purge solenoid valve. Refer to Plastic Collar Quick Connect Fitting Service .
- Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the nuts to 10 N·m (89 lb in).
