The malfunction indicator lamp (MIL) is located on the instrument panel cluster (IPC).
Ignition voltage is supplied to the MIL. The engine control module (ECM) turns the MIL ON by grounding the MIL control circuit. There should be a steady MIL with the ignition ON and the engine OFF.
• | The MIL informs the driver that a malfunction has occurred and the vehicle should be taken in for service as soon as possible. |
• | The MIL illuminates during a bulb test and a system test. |
• | A DTC will be stored if a MIL is requested by the ECM. |
• | The MIL will illuminate with the ignition switch ON and the engine OFF. |
• | The MIL will turn OFF when the engine is started. |
• | The MIL will remain ON if the self-diagnostic system has detected a malfunction. |
• | The MIL may turn OFF if the malfunction is not present. |
• | If the MIL is illuminated and then the engine stalls, the MIL will remain illuminated as long as the ignition switch is ON. |
• | If the MIL is not illuminated and the engine stalls, the MIL will not illuminate until the ignition switch is cycled OFF, then ON. |
The number below refers to the step number on the diagnostic table.
Step | Action | Values | Yes | No |
---|---|---|---|---|
Schematic Reference: Engine Controls Schematics Connector End View Reference: Engine Control Module Connector End Views or Engine Controls Connector End Views | ||||
1 | Did you perform the Diagnostic System Check - Vehicle? | -- | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
2 | Command the malfunction indicator lamp (MIL) ON and OFF with a scan tool. Does the MIL turn ON and OFF when commanded with a scan tool? | -- | Go to Intermittent Conditions | Go to Step 3 |
Is the voltage less than the specified value? | 0.3 V | Go to Step 4 | Go to Step 8 | |
4 |
Is the MIL illuminated? | -- | Go to Step 7 | Go to Step 5 |
5 | Test the MIL control circuit for an open or high resistance. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct a condition? | -- | Go to Step 11 | Go to Step 6 |
6 | Test for an intermittent and for a poor connection at the IPC. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 11 | Go to Step 9 |
7 | Test for an intermittent and for a poor connection at the ECM. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 11 | Go to Step 10 |
8 | Repair the short to voltage in the MIL control circuit. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | -- | Go to Step 11 | -- |
9 | Replace the IPC. Refer to Instrument Cluster Replacement in Instrument Panel, Gages, and Console. Did you complete the replacement? | -- | Go to Step 11 | -- |
10 | Replace the ECM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? | -- | Go to Step 11 | -- |
11 |
Does the vehicle operate correctly, without MIL illumination and without stored DTCs? | -- | System OK | Go to Diagnostic Trouble Code (DTC) List - Vehicle in Vehicle DTC Information |