Notice: Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.

1. Turn the ignition switch to the OFF position.
2. Clean the electronic brake control module (EBCM) to brake pressure modulator valve (BPMV) area of any accumulated dirt and foreign material.
3. Disconnect the electrical connector from the EBCM.



4. Remove the 4 EBCM-to-BPMV retaining bolts (1).



5. Separate the EBCM (1) from the BPMV (2) by carefully pulling apart.

1. Clean the sealing surface of the BPMV, with denatured alcohol and a clean shop cloth.
2. Install the EBCM (1) to the BPMV (2). Use care when aligning the EBCM (1) to the BPMV electrical terminals (3).

Notice: Refer to Fastener Notice in the Preface section.




3. Install the 4 EBCM-to-BPMV retaining bolts (1). Tighten the bolts in a criss-cross pattern.

Tighten
Tighten the bolts to 3 N·m (27 lb in).




4. Connect the electrical connector to the EBCM.
5. Turn the ignition switch to the ON position. DO NOT start engine.
6. Perform the Diagnostic System Check - Vehicle in Vehicle DTC Information.
7. Refer to Control Module References for programming and setup information.