GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Saturn 🢒 2006 🢒 ION 🢒 Body 🢒 Doors 🢒 Armrest Pull Cup Replacement

Removal Procedure

    Object Number: 864943 Size: SH

    Important: This procedure is for the front seat pull cup. Rear seat pull cup replacement is similar.

  1. Lift the pull cup liner.
  2. Remove the pull cup screws.

    3. Object Number: 865037 Size: SH
  3. Insert a small, flat-bladed tool under the rearward end of the pull cup and lift up.
  4. Pull rearward to disengage the pull cup hook.
  5. Disconnect the electrical connectors, if equipped.

Installation Procedure

    Object Number: 865037 Size: SH
  1. Connect the electrical connectors.
  2. Install the forward pull cup hook on the door trim.
  3. Push down on the rearward end of the pull cup until the cup snaps into place.

    4. Object Number: 864943 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the pull cup screws.

    5. Tighten
    Tighten the screws to 2.5 N·m (23 lb in).

  5. Reposition the pull cup liner.