Circuit Description
Some control modules must be configured with serial numbers, vehicle options, or other information. If a control module was not properly configured after installation, that module may set DTC B1001.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC B1001 Option Configuration Error
Conditions for Running the DTC
The ignition is ON.
Conditions for Setting the DTC
The control module is not configured properly.
Action Taken When the DTC Sets
| • | The SERVICE VEHICLE SOON indicator illuminates. |
| • | The check gages chime sounds. |
Conditions for Clearing the DTC
| • | A current DTC B1001 will clear when the module is correctly programmed. |
| • | A history DTC B1001 will clear after the ignition has been cycled 100 times, without a repeat of the malfunction. |
Diagnostic Aids
The most likely reasons for DTC B1001 being set are incorrect calibration files were downloaded to the module, or the module was replaced without the recalibration having been performed.
Test Description
The number below refers to the step number on the diagnostic table.
Step | Action | Yes | No |
|---|---|---|---|
Connector End View Reference: Master Electrical Component List | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |
2 |
Is DTC B1001 retrieved as current? | Go to Step 3 | Go to Diagnostic Aids |
Perform the programming or setup procedure for the module that set DTC B1001. Refer to Control Module References for the proper procedure. Does DTC 1001 reset? | Go to Step 4 | System OK | |
4 |
Important: Perform the programming or setup procedure for the module. Replace the module that set DTC B1001. Refer to Control Module References for the proper procedure. Did you complete the replacement? | System OK | -- |
