Manifold Absolute Pressure Sensor Replacement TMAP

1. Disconnect the temperature manifold absolute pressure (TMAP) sensor harness connector.
2. Remove the TMAP sensor from the intake manifold.

Important: If the TMAP sensor seal is damaged, the TMAP sensor must be replaced.

3. Inspect the seal for damage.

Notice: Refer to Fastener Notice in the Preface section.





Important: Use the new TMAP sensor seal provided with the new TMAP sensor.

1. Install the TMAP sensor into the intake manifold.

Tighten
Tighten the bolt to 10 N·m (89 lb in).

2. Connect the TMAP sensor harness connector.

Manifold Absolute Pressure Sensor Replacement SCIP

1. Disconnect the supercharger inlet pressure (SCIP) sensor harness connector.
2. Remove the SCIP sensor (1) from the supercharger.

Important: If the SCIP sensor seal is damaged, the SCIP sensor must be replaced.

3. Inspect the seal for damage.

Notice: Refer to Fastener Notice in the Preface section.





Important: Use the new SCIP sensor seal provided with the new SCIP sensor.

1. Install the SCIP sensor (1) into the intake manifold.

Tighten
Tighten the bolt to 10 N·m (89 lb in).

2. Connect the SCIP sensor harness connector.