Caution: Refer to SIR Caution in the Preface section.

1. Remove the rear compartment trim panel. Refer to Rear Compartment Trim Panel Replacement .
2. Record all of the vehicle preset radio stations.
3. Ensure that all lamps and accessories are OFF.
4. Ensure that the ignition switch is in the OFF position.

Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

5. Loosen the negative battery cable (2) bolt.
6. Remove the negative battery cable (3) from the battery.

Important: Clean any existing oxidation from the contact face of the battery terminal and battery cable using a wire brush before installing the battery cable to the battery terminal.

1. Position the negative battery cable (3) to the battery.

Notice: Refer to Fastener Notice in the Preface section.

2. Tighten the negative battery cable bolt (2).

Tighten
Tighten the bolt to 17 N·m (13 lb ft).

3. Install the rear compartment trim panel. Refer to Rear Compartment Trim Panel Replacement .
4. Reset the radio stations and the clock.