Schematic Reference: Headlights/Daytime Running Lights (DRL) Schematics

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle

1. Place the headlamp switch in the HEADLAMP position.
2. Place the headlamp dimmer switch in the LOW position.
3. Observe the headlamps.
4. Place the headlamp dimmer switch in the HIGH position.
5. Observe the headlamps.

Do both the low and high beam headlamps illuminate?

Go to Testing for Intermittent Conditions and Poor Connections

Go to Step 3

Test for an open or high resistance in the ground circuit of the headlamp switch. Refer to Circuit Testing and Wiring Repairs .

Did you find and correct the condition?

Go to Step 6

Go to Step 4

Inspect for poor connections at the harness connector of the headlamp switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .

Did you find and correct the condition?

Go to Step 6

Go to Step 5

Replace the headlamp switch. Refer to Turn Signal Multifunction Switch Replacement .

Did you complete the replacement?

Go to Step 6

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3