Schematic Reference: Headlights/Daytime Running Lights (DRL) Schematics

Connector End View Reference: Lighting Systems Connector End Views

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle

1. Place the headlamp switch in the HEAD position.
2. Place the headlamp dimmer switch in the LOW position.

Do the low beam headlamps illuminate?

Go to Testing for Intermittent Conditions and Poor Connections

Go to Step 3

1. Disconnect the headlamp switch.
2. Connect a 15-amp fused jumper wire between the headlamp low beam signal circuit and a good ground.

Do the low beam headlamps illuminate?

Go to Step 4

Go to Step 5

Inspect for poor connections at the harness of the headlamp switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .

Did you find and correct the condition?

Go to Step 7

Go to Step 6

Repair an open or high resistance in the headlamp low beam signal circuit. Refer to Circuit Testing and Wiring Repairs .

Did you complete the repair?

Go to Step 7

--

Replace the headlamp switch. Refer to Turn Signal Multifunction Switch Replacement .

Did you complete the replacement?

Go to Step 7

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3