GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Saturn 🢒 2007 🢒 ION 🢒 Safety and Security 🢒 Supplemental Inflatable Restraints 🢒 DTC B1328

Circuit Description

The body control module (BCM) has an internal voltage sensor with a dedicated circuit that checks the battery positive voltage and battery negative circuit voltage to determine if it is below 18 volts.

DTC Descriptor

This diagnostic procedure supports the following DTC:

DTC B1328 Device Power 1 Circuit High

Conditions for Running the DTC

This DTC shall run only if the BCM has power, ground, and the ignition is not in START mode. This DTC shall execute regardless of the battery voltage.

Conditions for Setting the DTC

This DTC shall be set as current when the voltage raises above 18 volts for 1,200 milliseconds.

Action Taken When the DTC Sets
    • The engine control module (ECM)/powertrain control module (PCM) will not illuminate the charge indicator.
    • This DTC shall be set as current when the voltage raises above 18 volts for 1,200 milliseconds.

A message shall be sent out on the class 2 lines to notify all other modules of low battery voltage.

Conditions for Clearing the MIL/DTC

In order to clear the DTC from a current status, the ignition must be cycled and the voltage shall be less than 18 volts.

Test Description

The number below refers to the step number on the diagnostic table.

  1. This step compares battery voltage with the voltage that the BCM calculates.

Step

Action

Value(s)

Yes

No

Connector End View Reference: Inline Harness Connector End Views or Data Communication Connector End Views

1

Did you perform the Diagnostic System Check - Vehicle?

--

Go to Step 2

Go to Diagnostic System Check - Vehicle

2
  1. Install a scan tool.
  2. Start the engine.
  3. Increase engine speed to above 1,500 RPM.
  4. With a scan tool, observe the Battery 1 parameter in the Ignition data list of the body control module (BCM).

Does the scan tool indicate the battery voltage is less than the specified value?

18 V

Go to Step 4

Go to Step 3

3

  1. Measure the voltage across the battery terminals.
  2. Compare the battery voltage with the Battery 1 parameter in the Ignition data list of the BCM.

Are the voltages within the specified value?

1 V

Go to Charging System Test

Go to Step 4

4

Inspect for poor connections at the harness connector of the BCM. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .

Did you find and correct the condition?

--

Go to Step 6

Go to Step 5

5

Replace the BCM. Refer to Control Module References for replacement, setup, and programming.

Did you complete the replacement?

--

Go to Step 6

--

6
  1. Use the scan tool in order to clear the DTC.
  2. Operate the vehicle within the Conditions for Running the DTC, as specified in the supporting text.

Does the DTC reset?

--

Go to Step 2

System OK