Circuit Description
The "Change Engine Oil" telltale is reset by depressing the oil life reset push-button
switch. This switch is located in the underhood junction block. Pressing this switch
grounds circuits 1579. When grounded, the body control module (BCM) request the engine
controller to perform an oil life reset. When the reset is completed, the BCM will
turn Off the "Change Engine Oil" telltale.
Conditions for Setting the DTC
| • | Ignition is in the "RUN" position |
| • | Vehicle speed is greater than 10 km/h (6 mph) |
| • | Circuit 1579 shorted to ground |
Diagnostic Aids
| • | Inspect the wiring harness for damage. Check for broken or chaffed insulation. |
| • | If fault is suspected to be intermittent, wiggling the harness wiring
may help in locating the fault. |
DTC B3538
