The oxygen sensor 1 (O2S-1) is electrical source that responds to oxygen content in the exhaust manifold. When the sensor reaches approximately 316°C (600°F), it produces a voltage based on the difference in oxygen between the atmosphere and exhaust gas. The PCM sends a bias voltage (399-499 mV) on the signal line, which is pulled up through high resistance. When the O2S-1 is cold, it produces no voltage and has extremely high internal resistance. The internal resistance of the sensor is much greater than the resistance of the bias pull-up resistor. However, when the sensor heats up, it produces voltage that overrides the bias voltage. This voltage is read by the PCM to determine a rich/lean 02S-1 signal used to adjust the injector pulse width. Under normal conditions, low sensor voltage means high oxygen content/lean air-fuel mixture and vice versa. Normal sensor readings will fluctuate between 10 mV and 1065 mV. DTC P0131 sets when the O2S-1 signal voltage is too low for a certain length of time.

DTC P0131 will set if O2S-1 voltage is below 52 mV for 2 minutes and 5 seconds when the following conditions have been met for 14 seconds:

DTC P0131 diagnostic runs continuously once the above conditions have been met.

P0131 is a (type B) DTC

To locate an intendment problem, use the scan tool to monitor the O2S-1 voltage with the ignition On, engine Off. Wiggling the wires while watching for a change from the bias voltage (399-499 mV) may locate the area where a short to ground in the wiring could lie.

If the system is commanding rich (engine running lean) the O2S-1 signal will be around 100 mV. The short term fuel trim value will be in the 160s as the system is near or at maximum correction.