GM Service Manual Online
For 1990-2009 cars only

Pressure Diagnosis

    • With vehicle on a level surface, allow adequate drain down time (2-3 minutes) and measure for a low oil level.
    • Add the recommended grade engine oil and fill the crankcase until the oil level measures full on the oil level indicator.
    • Run the engine and verify low or no oil pressure on the vehicle gauge or lamp.
    • Listen for a noisy valve train or a knocking noise.
    • Inspect for the following:
       - Oil diluted by moisture or unburned fuel mixtures
       - Improper oil viscosity for the expected temperature
       - Incorrect or malfunctioning oil pressure sender
       - Incorrect or malfunctioning oil pressure gauge
       - Plugged oil filter
       - Malfunctioning oil bypass valve
    • Remove the oil pressure sender or another engine block oil gallery plug.
    • Install a oil pressure gauge and measure the engine oil pressure.
    • If the engine oil pressure is below specifications, inspect the engine for one or more of the following:
       - Oil pump worn or dirty. Refer to Oil Pump Disassemble .
       - Oil pump-to-engine front cover bolts loose. Refer to Oil Pump Assemble procedure in this section of the service manual.
       - Oil pump screen loose, plugged, or damaged
       - Malfunctioning oil pump pressure regulator valve
       - Excessive bearing clearance. Refer to Crankshaft and Bearing Cleaning and Inspection procedure in this section of the service manual.
       - Cracked, porous or restricted oil galleries
       - Oil gallery plugs missing or incorrectly installed. Refer to Engine Block Disassemble procedure in this section of the service manual.
       - Broken lash adjusters

Pressure Check

Tools Required

    •  Oil Pressure Socket
    •  Oil Pressure Fitting
    •  Gage Bar Set

Object Number: 872892  Size: SH

Important: A shown in this chart, SAE 5W-30 is best for your vehicle. However, you can use SAE 10W-30 if it's going to be -7°C (20°F) or above. These numbers on an oil container show its viscosity, or thickness. Do not use engine oil with a viscosity rating such as SAE 10W-40, SAE 20W-50, and 30W as it does not meet Saturn recommended requirements.

Engine Additives:

Don't add anything to your oil. Your Saturn Retailer is ready to advise if something should be added.


    Object Number: 897585  Size: SH

    Important: The oil level should be 4.76 mm (3/16 in) above or below the MAX line on the dipstick, after the engine's oil and filter have been changed. If the oil level is at or below the MIN line, check for oil leaks and add oil up to the MAX line.

  1. Check the engine oil level.

  2. Object Number: 897643  Size: SH
  3. Using the , remove the oil pressure switch.

  4. Object Number: 897587  Size: SH
  5. Install the and the , LL0 shown, L61 similar.
  6. Start the engine and warm to the normal temperature.
  7. Important: Check for oil leakage after installing the oil pressure switch.

  8. Check the oil pressure.
  9. Specification
    The oil pressure at 1000 RPM is 344.75-531.60 kPa (50-80 psi).

    Tighten
    Tighten the oil pressure sensor to block to 35 N·m (26 lb ft).