Gear Teeth Counts and Ratios
GearTeeth Count | |
|---|---|
1st Drive | 13 |
1st Driven | 44 |
2nd Drive | 25 |
2nd Driven | 44 |
3rd Drive | 39 |
3rd Driven | 46 |
4th Drive | 47 |
4th Driven | 42 |
5th Drive | 54 |
5th Driven | 38 |
Reverse Drive | 25 |
Reverse Idler | 21 |
1st & 2nd Gear Synchronizer Sleeve | 49 |
Output Shaft | 20 |
Ring Gear | 89 |
Blocking Ring Clearances
Measure | Standard | Service Limit | ||
|---|---|---|---|---|
Metric | English | Metric | English | |
1st and 2nd Gears | 1.2-1.4 mm (min.) | 0.047-0.055 in (min.) | 0.8 mm (min.) | 0.032 in (min.) |
3rd, 4th, and Reverse Gears | 0.9-1.2 mm (min.) | 0.035-0.047 in (min.) | 0.5 mm (min.) | 0.020 in (min.) |
5th Gear | 0.7-1.1 mm (min.) | 0.028-0.043 in (min.) | 0.5 mm (min.) | 0.020 in (min.) |
Axial Play Specifications
Measurement | Specification | |
|---|---|---|
Metric | English | |
Between 2nd and 3rd Drive Gears | 0.05-0.40 mm | 0.002-0.016 in |
Between 4th Drive Gear and Input Shaft Bearing | 0.05-0.40 mm | 0.002-0.016 in |
Between Reverse Gear and Reverse Gear Washer | 0.10-0.20 mm | 0.004-0.008 in |
Input Shaft Axial Play | 0.09-0.15 mm | 0.004-0.006 in |
Output Shaft Axial Play | This is a calculated value, it can change based upon age of case and output shaft bearing, refer to "Transaxle Assembly" in this service manual. | |
