Removal Procedure
- Remove the center trim plate. Refer to
Instrument Panel Center Trim Panel Replacement
in Instrument Panel,
Gages, and Console.
- Remove the radio fasteners.
- Pull the radio out slightly to access the rear of the radio.
- Disconnect the electrical connectors, antenna, and radio ground strap
spade terminal from the rear of the radio.
- Remove the radio.
Installation Procedure
- Connect the radio ground strap spade terminal, electrical connectors, and antenna
to the rear of the radio.
- Install the radio by sliding it into the guides on the instrument panel
(I/P).
Notice: Refer to Fastener Notice in the Preface section.
- Install the radio fasteners.
Tighten
Tighten the fasteners to 2.5 N·m (22 lb in).
- Install the center trim plate. Refer to
Instrument Panel Center Trim Panel Replacement
in Instrument Panel,
Gages, and Console.