Important: Some parts have structural weld-thru adhesive in the joint areas. It is necessary
to replace this with additional spot welds at the attachment points. This can be accomplished
by adding an additional weld between each factory weld in all areas.
- Note amount and location of spot welds.
- Remove sealer and drill spot welds from:
| 2.1. | Panel assembly body side inner |
| 2.3. | Rail assembly panel compartment longitudinal |
| 2.4. | Panel assembly rear seat to back window (sedan) |
- Clean all weld seams with a wire brush. Prime and seal all repair areas.
- Apply permanent underbody sealant.
Important: Ensure that proper corrosion proctection processes are used on all repair areas.
- Prime with two-part catalyzed primer.
- Apply sealers and corrosion protection materials according to information
in the "Body Paint" section of this service manual or paint manufacturer's recommendations.
- Construct joint in sail panel area. Construct reinforcement for the joint
butt weld area. Clean surface for welding and grind primer off new part at connecting
points. Apply 3M® Weld-Thru Coating P/N 05913 (or equivalent) to all areas to
be welded, apply structural adhesive to fuel fill tube pocket.
- Measure and align. Clamp in place.
- Use MIG to plug weld.
