For 1990-2009 cars only
- Note amount and location of spot welds.
- Drill the spot welds from the striker plate.
- Clean all weld seams with a wire brush.
- Prime and seal all repair areas.
- Apply permanent underbody sealant.
- Apply sealers and corrosion protection materials according to information in the Body Paint section of this service manual or paint manufacturer's recommendations.
- Clean surface for welding and grind primer off new part at connecting points. Apply 3M® Weld-Thru Coating P/N 05913, or equivalent, to all areas to be welded.
- Measure and align. Clamp in place.
- Use MIG to plug weld.
Important: It is important that the proper corrosion protection processes are used on all repair areas. Prime with two-part catalyzed primer.
