Removal Procedure
- Remove the upper trim panel. Refer to
Upper Extension Trim Panel Replacement
.
- Remove the pull door handle. Refer to
Front Side Door Pull Handle Replacement
- Remove the power door lock switch. Refer to
Door Lock Switch Replacement - Front
- Remove the lower fasteners from the door trim
panel.
- On manual window vehicles, remove the window crank handle.
- Using a door pad removal tool, disengage the door trim retainers.
- Lift upward on the door trim panel to disengage the panel from the door.
- On vehicles with an illuminated door trim pad, hold the door panel away
from the door structure and disconnect the wiring harness.
- Remove the door trim panel.
Installation Procedure
- If the door trim panel is being replaced with a new panel, transfer the
door panel lamp assembly to the new panel.
- Place the door panel over the top inner door structure.
- Connect the wiring harness for the panel illumination.
- Pull down to engage the door trim panel to the door structure.
- Apply pressure to the retainers to secure the panel to the door structure.
Notice: Refer to Fastener Notice in the Preface section.
- Install the lower fasteners to the door trim panel.
Tighten
Tighten the fasteners to 2 N·m (17.7 lb in).
- On manual window vehicles, install the window crank handle.
- Install the power door lock switch. Refer to
Door Lock Switch Replacement - Front
.
- Install the pull handle. Refer to
Front Side Door Pull Handle Replacement
.
- Install the upper trim panel. Refer to
Upper Extension Trim Panel Replacement
.