Programming Procedure (Passlock™)
There are 2 methods used to program/reprogram the Passlock™ system. These are the Saturn service stall method and the auto learn method.
Saturn Service Stall Method
| • | This method takes about 10 minutes for programming. |
| • | A programming system is required. Refer to Saturn Service Stall/Tech 2 User Guide. |
| • | A scan tool is required. |
Auto Learn Method (Optional)
| • | This method is usable if the Passlock™ sensor ECM/PCM replacement was required. |
| • | This method takes about 30 minutes. |
| • | A scan tool is not required. |
Both methods are included in the flow chart security system relearn procedure.
Important: If no Passlock™ components are replaced the 30 minute auto-lean can always be used.
The following shows when the relearn procedure needs to be performed.
Controller Replaced:
BCM:
- The new service BCM will automatically learn the voltage code from the Passlock™ sensor.
- The password from the BCM to the PCM/ECM requires the Saturn service stall to learn the new password in order to enable the fuel and start the vehicle. Initiate the 10 minute relearn procedure.
- The RKE transmitters will carry over from the previous BCM when using the Saturn service stall system.
PCM: (4 cylinder)
The Saturn service stall system will be required. Initiate the 10 minute relearn for the fuel to enable the password from the existing BCM.
ECM: (6 cylinder)
The Saturn service stall system will be required to initiate the 10 minute relearn for the fuel to enable the password from the existing BCM.
TCM: (6 cylinder)
No relearn required for the controller replacement.
Passlock™ Sensor (Ignition Module)
The Saturn service stall will be required to initiate the 10 minute relearn procedure for the existing BCM.
