GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 43650 Balance Shaft Bushing Remover/Installer


    Object Number: 598032  Size: SH
  1. Install the balance shaft bushing using the J 43650 .

  2. Object Number: 598033  Size: SH
  3. Seat the balance shaft bushing into the bore using the J 43650 and a wrench.
  4. When the J 43650 is fully seated in the engine block remove it with a wrench.

  5. Object Number: 412419  Size: SH

    Important: If the balance shafts are not properly timed to the engine, the engine may vibrate or make noise.

    Install the balance shaft assemblies to the engine using the following steps:

  6. Place the number one piston at TDC.
  7. Install the balance shaft drive chain sprocket on the crankshaft.
  8. Lubricate the balance shaft lobes with engine oil.
  9. Install the balance shafts into their bores.
  10. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  11. Install the balance shaft retaining bolts.
  12. Tighten
    Tighten the balance shaft retaining bolts to 10 N·m (89 lb in).

Tools Required

J 43650 Balance Shaft Bearing Remover/Installer


    Object Number: 897467  Size: SH
  1. Install the balance shaft bushing using the J 43650 .

  2. Object Number: 897465  Size: SH
  3. Seat the balance shaft bushing into the bore using the J 43650 and a wrench.
  4. When the J 43650 is fully seated in the engine block, remove it with a wrench.

  5. Object Number: 895529  Size: SH

    Important: If the balance shafts are not properly timed to the engine, the engine may vibrate or make noise.

    Important: Install the balance shaft assemblies to the engine using the following steps:

  6. Place the number one piston at top dead center (TDC).
  7. Install the balance shaft drive chain sprocket on the crankshaft
  8. Install the balance shafts into their bores.
  9. Install the balance shaft retaining bolts.
  10. Tighten
    Tighten the balance shaft retaining bolts to 10 N·m (89 lb in).


    Object Number: 897591  Size: SH
  11. Align the arrow on the exhaust sprocket with the notch on the carrier. The arrow should point down.

  12. Object Number: 897590  Size: SH
  13. Align the arrow on the intake sprocket with the notch on the carrier. The arrow should point up.