The heated oxygen sensor (HO2S) bank 2 sensor 1 is threaded into the cylinder 2, 4, 6 exhaust manifold (cylinders 2, 4 and 6 are closest to the radiator). The sensor is equipped with a heater element to decrease the amount of time required to enter closed loop fuel control. The ECM controls the heater by pulsing circuit 551 to ground. When the heater is commanded Off (circuit not grounded), the voltage level at the ECM should be high (ignition voltage). When the heater is commanded On (circuit grounded), the voltage level at the ECM should be low. The ECM heater feedback circuit uses a pull-up voltage (1.6-3.6 volts), which allows the ECM to individually differentiate between an open, short to ground or short to voltage. DTC P0052 will set if the ECM detects higher than normal feedback voltage when the HO2S bank 2 sensor 1 heater is commanded On with the engine running.
DTC PARAMETERS
DTC P0052 will set if the HO2S bank 2 sensor 1 heater feedback voltage is greater than 3.6 volts. The heater is commanded On when:
| • | The condition exists for longer than 0.4 seconds. |
| • | The engine is running. |
| • | The battery voltage is between 11.0-15.0 volts. |
DTC P0052 diagnostic runs continuously once the above conditions have been met.
P0052 is a type B DTC.
DIAGNOSTIC AIDS
To locate an intermittent problem, use the scan tool to monitor the HO2S HEATER BN. 2 SEN. 1 with the engine running. The voltage should fluctuate greater than 1 volt, indicating the circuit is functioning correctly. Compare this parameter to the HO2S HEATER BN. 1 SEN. 1 parameter. Both parameters should closely match. The voltage will not change greater than 1 volt when a short to voltage or shorted heater element occurs.
Heater element resistance: 2.4-9.2 ohms
