Circuit Description
The SDM contains a sensing device that converts the vehicle velocity changes
to an electrical signal. the electrical signal is generated by the SDM and compared
to a value stored in the memory. When the generatecd signals exceed the stored values,
the SDM deploys the air bags and stores a DTC in its memory. if a deployment occurs
while an inflator cirucit fault is present this DTC will be set.
Conditions for Setting the DTC
DTC B0053 sets when the SDM commands the inflator modules to deploy the air
bags with a loop fault present. The following conditions must be met to set this
DTC.
| • | Ignition voltage is present at the SDM and continuous. |
| • | An inflator loop fault was previously detected. |
| • | The SDM detects a frontal or side impact. |
| • | Impact was of sufficient force to warrant deployment of the air bags. |
Action Taken When the DTC Sets
| • | The air bag telltale will be on. |
| • | DTC is latched in the SDM memory. |
Diagnostic Aids
| • | Always start diagnosis of the SIR DTCs with an inspection of the vehicle,
including its wiring and the SIR components for visible damage. |
| | Important: DTC B0053 is a a latched code and can not be cleared from the SDM memory.
|
| • | Always replace the SDMs with DTC B0053 set, only after all the collision repairs
have been completed. |
B0053
