Circuit Description
When intermittent or mist operation of the windshield wiper is selected, battery
voltage from the wiper switch is applied to the front wiper input of the body control
module (BCM). The BCM responds by switching circuit 1445 to ground. This action energizes
the front wiper relay, providing low speed operation of the wiper motor during single
swipes.
Control of the wiper during continuous LO or HI speed switch settings is direct
wired from the wiper switch to the wiper motor and is not under the control of the
BCM.
Conditions for Setting the DTC
| • | Ignition is in RUN or ACC position |
| • | Circuit 1445, BCM is shorted to ground or open |
| • | No light will illuminate in I/P. |
| • | If open, you will not have intermittent wipers. |
| • | If shorted to ground, wipers will always be on. |
Diagnostic Aids
| • | Inspect wiring harness for damage. Check for broken or chaffed insulation. |
| • | If fault is suspected to be intermittent, wiggling harness wiring may
help in locating fault. |
| • | Check for poor connection at the BCM. Inspect harness connections for
backed out terminals, improper terminal mating, broken connectors locks, improperly
formed or damaged terminals and poor terminal-to-wire connection (terminal crimped
over wire insulation not conductors). |
