For 1990-2009 cars only
Removal Procedure
- Operate the sunroof to the ¼ open position.
- Remove the 4 screws from the sunroof garnish molding.
- Close the sunroof and put in the vent position.
- Remove the sunroof garnish molding by releasing the sides and the lower molding down into the passenger compartment.
- Remove the sunroof window. Refer to Sunroof Air Deflector Replacement .
- Remove the water channel screws.
- Slide the sunshade forward.
- Remove the sunshade from the above vehicle by pressing the sunshade guide clips.
- If the sunshade clips are to be replaced, remove the sunshade guide clips by using a small screwdriver to bend the retaining tangs up.
Installation Procedure
- If the sunshade guide clips were replaced, install the sunshade guide clips by pressing the clips onto the sunshade where the old clips were located.
- Install the sunshade from above the vehicle by installing the 2 sunshade guide clips.
- Slightly tilting one side of the sunshade more forward than the other side, install the remaining 2 guide clips by pressing the guide clip and pushing into the channel.
- Install the water channel screws. Tighten the driver side screw first and the passenger side screw in the second slot.
- Install the sunroof window. Refer to Sunroof Air Deflector Replacement .
- Install the sunroof garnish molding by pressing the sides to the sunroof assembly.
- Operate the sunroof to the ¼ open position.
- Install the 4 screws to the sunroof garnish molding.
This will help to engage the clips into the channel.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the water channel screws to 3 N·m (27 lb in).
Tighten
Tighten the screws to 4 N·m (35 lb in).
