Diagnostic Instructions
DTC Descriptors
DTC C0131 00: ABS Pressure Circuit
DTC C0131 3A: ABS Pressure Circuit Incorrect Component Installed
DTC C0131 5A: Pressure Circuit Plausibility Failure
Circuit/System Description
The electronic brake control module (EBCM) uses input from the brake pressure sensor for vehicle stability enhancement system (VSES) functions. The brake pressure sensor is internal to the brake pressure modulator valve (BPMV).
Conditions for Running the DTC
| • | Ignition voltage is greater than 10 volts. |
Conditions for Setting the DTC
C0131 00
| • | Sensor supply voltage is less than 4.5 volts or greater than 5.3 volts for more than 1 sec. |
| • | Sensor signal voltage is less than 0.12 volts or greater than 3.2 volts for more than 1 sec. |
C0131 3A
EBCM has been replaced and the calibration to the brake pressure sensor is outside of programed range.
C0131 5A
| • | The EBCM detects the brake pressure does not increase when braking, when it received a message that the brake pedal is applied. |
| • | The EBCM detects the brake pressure is increasing when braking, and did not receive a message that the brake pedal is applied. |
| • | Internal pressure sensor fault. |
Action Taken When the DTC Sets
| • | The EBCM disables the ABS/traction control system (TCS)/vehicle stability enhancement system (VSES) for the duration of the ignition cycle. |
| • | A DIC message and/or a warning indicator may be displayed. |
Conditions for Clearing the DTC
| • | The condition for the DTC is no longer present. |
| • | The EBCM clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles. |
Diagnostic Aids
A C0131 can get set if the ECU is loosely attached to the hydraulic unit. The mountings should be checked for the proper torque.
Reference Information
Schematic Reference
Antilock Brake System Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
ABS Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
C0131 00 or C0131 5A
- Apply and release brake pedal. Verify brake lamps operate properly.
- Replace EBCM/BPMV assembly.
C0131 3A
Verify DTC C0131 3A is not set.
| ⇒ | If DTC is set, perform the scan tool EBCM special function, Brake Pressure Sensor Calibration. |
Repair Instructions
Perform the
Diagnostic Repair Verification after completing the diagnostic procedure.
