For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC C0561 71: System Disabled Information Stored Invalid Serial Data ReceivedDiagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
System Disabled Information Stored Invalid Serial Data Received | -- | -- | -- | C0561 71 |
Circuit/System Description
The electronic brake control module (EBCM) receives messages from other modules over GMLAN which are needed to perform antilock brake system (ABS), vehicle stability enhancement system (VSES), or traction control system (TCS) functions.
Conditions for Running the DTC
| • | The ignition switch is in the ON position. |
| • | Ignition voltage is greater than 9.5 volts. |
Conditions for Setting the DTC
The EBCM receives an invalid message from another module over GMLAN which causes EBCM to deactivate ABS, VSES, TCS, etc.
Action Taken When the DTC Sets
One or more of the following actions may occur:
| • | The EBCM disables the ABS/TCS/VSES for the duration of the ignition cycle. |
| • | The dynamic rear proportioning (DRP) may be disabled and the Brake Warning indicator may turn ON. |
| • | The Stability Caution indicator turns ON. |
| • | The driver information center (DIC) displays the SERVICE STAB SYS message. |
| • | The DIC displays the TRACTION FAILED message. |
Conditions for Clearing the DTC
| • | The condition for the DTC is no longer present. |
| • | The EBCM automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles. |
Reference Information
Schematic Reference
Antilock Brake System Schematics
Connector End View Reference
Antilock Brake System Connector End Views
Description and Operation
Electrical Information Reference
Scan Tool Reference
Scan Tool Data List for EBCM
Circuit/System Verification
- Perform the Diagnostic System Check - Vehicle .
- With Tech 2, view "Signals" Data Display list under EBCM.
- Refer to appropriate module for diagnosing any "invalid" signals.
- If no invalid signals are present, view "Signal Fault" data in "Enhanced DTC Data".
- Refer to appropriate module for diagnosing that invalid message data.
- Do not replace the EBCM due to this DTC fault.
| ⇒ | Diagnose any other Vehicle DTCs before attempting diagnosis of C0561. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
