Information on Roof Panel Joint Finish (Ditch) Molding Retainer Clip
| Subject: | Information on Roof Panel Joint Finish (Ditch) Molding Retainer Clip |
| Models: | 2007 GMC Acadia |
| 2007 Saturn Outlook |
This bulletin is being issued to provide dealers with information on the availability and replacement of the roof panel joint finish molding retainer clip. If the retainer clip needs replacement, use the procedure listed below. Also, until the retainer clip is available through GMSPO, it can be obtained from the GM Warranty Parts Center (WPC).
- Lift the roof panel molding in order to access the retainer clip.
- Carefully cut the epoxy bond at both edges of the retainer clip using a sharp tool.
- Cut far enough into the epoxy in order to help release the retainer clip and not damage the painted surface of the ditch.
- Protect the painted surface of the ditch using a clean towel when releasing the retainer from the ditch.
- Use fine grit sand paper to scuff the bonding surface where the new retainer clip will be installed.
- Wipe the surface with the alcohol solution and let the solution evaporate prior to bonding the new clip.
- Position and secure the new retainer clip to the molding.
- Apply adhesive, 3M Duramix™ Super-Fast Adhesive, or equivalent, to the underside of the retainer.
- Press the ditch molding into the ditch to achieve proper positioning.
- Place a small piece of wooden block, or equivalent, above the molding to gain downward pressure for proper clip position.
- Apply masking tape over the wooden block and secure to the body.
- Allow approximately 15 minutes to develop sufficient bond strength.
- Remove the masking tape after the bonding time has elapsed.
Notice: Use a plastic, flat-bladed tool to prevent damage when removing the molding.
Important: Ambient and body panel temperature should be at least 21°C (70°F) prior to bonding.
Parts Information
To obtain the new retainer, fax the form included in this bulletin to the GM Warranty Parts Center (WPC).
Warranty Information
For vehicles repaired under warranty, use:
Labor Operation | Description | Labor Time |
|---|---|---|
B9816* | Replace Roof Panel Joint Finish Molding Retainer Clip | 0.3 hr |
Add | To Replace Each Additional Retainer Clip | 0.2 hr |
* This is a unique labor operation number for bulletin use only. This number will not be published in the Labor Time Guide. | ||
IMPORTANT NOTE WHEN PRINTING THIS FORM: If the form prints out on two pages, make certain you fax BOTH pages so that the WPC receives all the needed information. Missing information will delay or prevent the part from being shipped.
Parts Request Form - Warranty Parts Center |
|---|
To: Warranty Parts Center
e-mail: warrantypartscenterUSA@gm.com
or WPC Fax: 248-371-0192
Attn: Jeannette Dunn
Part Being Requested: Roof Molding Retainer Clip (1 piece) WPC #376
Dealer BAC (U.S.) / Dealer Code (Canada):
Dealer Name:
Dealer Address:
Dealer Contact Person:
Dealer Phone Number:
Repair Order Number:
Vehicle VIN:
Important: If you do not receive the part within 2 business days after emailing or faxing your part request to the Warranty Parts Center, please call Customer Assistance at 248-371-9901/9902. IMPORTANT NOTE WHEN PRINTING THIS FORM: If the form prints out on two pages, make certain you fax BOTH pages so that the WPC receives all the needed information. Missing information will delay or prevent the part from being shipped. |
