Removal Procedure
- Remove the underhood bussed electrical center (UBEC). Refer to
Underhood Electrical Center or Junction Block Replacement
.
- Remove the body wiring harness/engine wiring harness electrical connection clip from the UBEC bracket.
- Remove the UBEC bracket bolt and nuts.
- Remove the UBEC bracket.
- Disconnect the engine wiring harness electrical connector(s) (1) from the ignition coil(s) (4).
- Remove the ignition coil bolt(s).
- Remove the ignition coil(s).
Installation Procedure
- Install the ignition coil(s).
Notice: Refer to Fastener Notice in the Preface section.
- Install the ignition coil bolt(s).
Tighten
Tighten the bolt(s) to 10 N·m (89 lb in).
- Connect the engine wiring harness electrical connector(s) (1) to the ignition coil(s) (4).
- Install the UBEC bracket.
- Install the UBEC bracket bolt and nuts.
Tighten
Tighten the bolt/nuts to 10 N·m (89 lb in).
- Install the body wiring harness/engine wiring harness electrical connection clip to the UBEC bracket.
- Install the UBEC. Refer to
Underhood Electrical Center or Junction Block Replacement
.