Stability System Caution Indicator Inoperative. Saturn OUTLOOK

For 1990-2009 cars only

Makes 🢒 Saturn 🢒 2007 🢒 OUTLOOK - FWD 🢒 Brakes 🢒 Antilock Brake System 🢒 Stability System Caution Indicator Inoperative

Diagnostic Instructions

•	Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

•	Review Strategy Based Diagnosis for an overview of the diagnostic approach.

•	Diagnostic Procedure Instructions provides an overview of each diagnostic category.

The instrument panel cluster (IPC) illuminates the stability system caution indicator during the IPC bulb check or when the electronic brake control module (EBCM) sends a serial data message to the IPC commanding the indicator ON.

Reference Information

Schematic Reference

Antilock Brake System Schematics

Connector End View Reference

•	Antilock Brake System Connector End Views

•	Displays and Gages Connector End Views

Electrical Information Reference

•	Circuit Testing

•	Connector Repairs

•	Testing for Intermittent Conditions and Poor Connections

•	Wiring Repairs

Scan Tool Reference

Scan Tool Data List

Circuit/System Verification

Ignition ON, observe the stability system caution indicator to turn ON, then OFF during the IPC bulb test.

Circuit/System Testing

Important: Diagnose all vehicle DTCs before using this diagnostic.

Ignition On, perform the display test with a scan tool, the stability system caution indicator should turn ON then OFF.

⇒	If the stability system caution indicator does not turn OFF, replace the IPC.

Replace the EBCM.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for EBCM or IPC replacement, setup, and programming