Callout
| Component Name
|
Preliminary Procedures
- Open the rear liftgate.
- Remove the interior liftgate garnish molding. Refer to
Liftgate Garnish Molding Replacement
.
- Disconnect the center high mounted stop lamp electrical connector.
|
1
| Rear Spoiler Nut (Qty: 5)
Notice: Refer to Fastener Notice in the Preface section.
Tighten 6 N·m (53 lb) |
2
| Integral Spoiler Clip (Qty: 4)
Procedure
- Insert a flat-bladed tool into the access holes in the inner liftgate panel in order to release the clips while lifting up on the outside edges of the rear spoiler.
- Release the integral clips from across the upper liftgate flange working from the outboard edge inward.
|
3
| Rear Spoiler
Tip Remove and transfer the high mounted stop lamp. Refer to
High Mount Stop Lamp Replacement
. |