• | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
• | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
• | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
---|---|---|---|---|
Courtesy Lamps Voltage Supply | B2615 00 | B2615 00 | B2615 00 | -- |
Courtesy Lamp Ground | -- | 1 | -- | -- |
1. Courtesy Lamps Inoperative |
Voltage for the courtesy lamps is supplied from body control module (BCM), driver door switch, and passenger door switch . When a door is opened, a signal is applied to the door module. The door module then applies a message on the low speed GMLAN serial data communication circuit to the BCM to activate the courtesy lamps. The BCM then applies voltage to the courtesy lamps voltage supply circuit and the components on that circuit.
The ignition is ON, the BCM, driver door switch, and passenger door switch attempt to illuminate the courtesy lamps.
The BCM, driver door switch, or passenger door switch detects a short to ground, short to voltage, or open on the courtesy lamp voltage supply circuit.
The BCM, driver door switch, and passenger door switch cease attempts to illuminate the courtesy lamps.
• | The conditions for setting the DTC are no longer present. |
• | A history DTC clears after 100 malfunction-free ignition cycles. |
• | The BCM receives the clear code command from the scan tool. |
Lighting Systems Connector End Views
Ignition ON, activate the Courtesy Lamps output control with the scan tool. The interior courtesy lamps should illuminate.
⇒ | If the DTC resets, test for a short to voltage, short to ground, or an open in the courtesy lamps supply voltage circuit. If the circuit/connections test normal, replace the BCM, driver door switch, and passenger door switch as applicable. |
⇒ | If the DTC resets, replace that particular component. |
⇒ | If the DTC does not reset, replace the BCM. |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
• | Refer to the appropriate replacement procedure for the component causing the condition. |
• | Control Module References for BCM, driver door switch, and passenger door switch replacement, setup, and programming |