Evaporative Emission Canister Replacement Long Wheel Base
Removal Procedure
- Remove the fuel tank. Refer to
Fuel Tank Replacement
.
- Disconnect the evaporative emission (EVAP) canister
vent pipe (6) from the EVAP canister (2).
- Disconnect the EVAP canister vapor pipe from the EVAP canister.
- Disconnect the EVAP canister purge pipe from the EVAP canister.
- Remove the EVAP canister (2) from the fuel tank.
Installation Procedure
Important: High resistance is normal when installing the EVAP canister.
- Position and push the EVAP canister (2) into the EVAP canister bracket
of the fuel tank.
- Pull up on the EVAP canister (2) to ensure a proper lock to the
fuel tank bracket.
- Connect the EVAP canister purge pipe to the EVAP canister.
- Connect the EVAP canister vapor pipe to the EVAP canister.
- Connect the EVAP canister vent pipe (6) to the EVAP canister (2).
- Install the fuel tank. Refer to
Fuel Tank Replacement
.
Evaporative Emission Canister Replacement Short Wheel Base
Removal Procedure
- Raise the vehicle. Refer to
Lifting and Jacking the Vehicle
in General Information.
- Disconnect the evaporative emission (EVAP) vent
hose, purge pipe (6), and vapor pipe from the EVAP canister (1).
- Remove the forward attaching nut from the EVAP canister bracket.
- Remove the two rear attaching nuts from the EVAP canister bracket at the
fuel tank.
- Lower the EVAP canister assembly.
- Pull the rear canister bracket flange away from the EVAP canister.
- Lift the rear of the EVAP canister from the bracket to release the forward
tab.
Installation Procedure
- Install the EVAP canister into the forward tab of the canister bracket.
- Press the rear of the EVAP canister down in order to engage the rear bracket
tabs.
- Install the EVAP canister assembly to the fuel
tank.
Notice: Refer to Fastener Notice in the Preface section.
- Install the two attaching nuts to the EVAP canister bracket at the fuel tank
studs.
Tighten
Tighten the nut to 9 N·m (80 lb in).
- Install the forward attaching nut to the canister bracket.
Tighten
Tighten the nut to 9 N·m (80 lb in).
- Connect the EVAP vent hose, purge pipe (6), and vapor pipe to the
EVAP canister (1).
- Lower the vehicle.