Parking Brake Rear Cable Replacement - Right Side With IRS

Tools Required

J 37043 Park Brake Cable Release Tool

Caution: Refer to Park Brake Cable to Caliper Caution in the Preface section.

1. Remove the right rear wheel and tire. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
2. Loosen the adjusting nut.



3. Remove the right rear brake cable (1) from the connector (2).



4. Remove the inner cable (1) from the brake caliper retaining bracket.



5. Push the inner cable (1) as far forward as possible.
6. Rotate the tip of the inner cable toward the brake caliper and remove from the actuator (2).



7. Remove the brake cable from the vehicle.

1. Install the brake cable in the brake caliper.



2. Position the inner cable (1) in the actuator (2).



3. Pull the inner cable (1) until the tip is seated in the actuator.



4. Install the brake cable in the retaining bracket (1) on the brake caliper.




Important: Maintain proper rear park brake cable routing and clearances. Verify the rear park brake cables have a minimum of 10 mm and a maximum of 12 mm of clearance to the wheel drive shafts (1). Maintain this clearance using retention straps or equivalent retention (2).

5. Ensure the rear park brake cable and routing clearances have a minimum of 10 mm and a maximum of 12 mm of clearance to the wheel drive shafts.



6. Install the brake cable (1) in the mounting bracket.



7. Install the brake cable (1) in the connector (2).



8. Install the adjusting nut.
9. Adjust the park brakes. Refer to Park Brake Adjustment .
10. Install the right rear tire and wheel. Refer to Tire and Wheel Removal and Installation .