Tools Required
J 44587 Main Shaft Holder
- Install the intermediate carrier module (2).
- Rotate the intermediate carrier module (2) until the module drops
into place.
Notice: Installing the thrust bearing incorrectly may cause permanent
damage to the transmission.
- Align thrust bearing assembly (1) so that the blue stripe on the thrust
bearing assembly is facing towards the intermediate carrier module (2).
- Install the thrust bearing assembly (1) onto the intermediate carrier
module (2).
Notice: Do not rotate the transmission
from the nose-up position without installing J 44587. Failure to install J 44587
and rotating the transmission will cause clearance issues during assembly
and possible damage to the transmission.
- Align J 44587
(1)
with the power takeoff (PTO) access as follows:
• | The tongue of J 44587
is
facing toward the PTO access. |
• | The bolts holes of J 44587
are aligned with the 2 front bolt holes of the PTO access. |
- Install J 44587
(1)
into the PTO access.
- Install 2 bolts (2) into J 44587
(1) and tighten the bolts snugly.
- Install the intermediate sun gear (3) and the sun gear spacer (2)
onto the main shaft (4).
- As a unit, install the main shaft (4), the intermediate sun gear (3),
and the sun gear spacer (2) into the intermediate planetary carrier module (5).
- Align the output sun gear (1) so that the flat side of the sun
gear is facing the sun gear spacer.
- Install the output sun gear (1) onto the main shaft (4).
- Make sure the output sun gear and sun gear spacer splines are engaged.
Notice: Installing the thrust bearing incorrectly may cause permanent
damage to the transmission.
- Align the thrust bearing assembly (1) so that the blue stripe on the
thrust bearing assembly is facing away from the output sun gear (2).
- Install the thrust bearing assembly (1) into the output sun gear (2).