The mobility seat module monitors an input from a hall effect sensor in the rotation motor while the seat is being rotated in or out. The hall effect is a 12-volt 3-wire sensor and the signal circuit is referenced from battery voltage within the module.
This diagnostic procedure supports the following DTC:
DTC 034 Swivel Motor Hall Sensor Circuit Fault During Inward Rotation
• | Battery voltage must be within 9-16 volts. |
• | Seat operation is attempted from the outward facing position. |
When rotating the seat to the forward facing position no hall effect sensor pulses are detected by the module.
While the fault is current the module will disable the object detection feature and the alarm will sound during rotation motor operation.
The DTC may be cleared by removing the main power supply or ground from the seat module.
Step | Action | Yes | No |
---|---|---|---|
Schematic Reference: Passenger Seat Schematics Connector End View Reference: Power Seat Connector End Views | |||
1 | Did you review the description and operation and perform the necessary inspections? | Go to Step 2 | |
2 | Verify the fault is present. Does the system operate normally? | Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 |
3 | Does the seat rotate to the forward facing position? | Go to Step 4 | Go to Step 7 |
4 |
Is battery voltage present? | Go to Step 5 | Go to Step 8 |
5 | Measure the voltage between the hall effect sensor supply circuit terminal and the ground circuit terminal in the harness connector. Is battery voltage present? | Go to Step 6 | Go to Step 9 |
6 | Measure the voltage at the hall effect sensor signal circuit terminal in the harness connector. Is battery voltage present? | Go to Step 13 | Go to Step 10 |
7 |
Does the test lamp illuminate? | Go to Step 13 | Go to Step 11 |
8 | Test the hall effect sensor supply circuit for an open or short to ground. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | Go to Step 14 | Go to Step 12 |
9 | Test the hall effect sensor ground circuit for an open or high resistance. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | Go to Step 14 | Go to Step 12 |
10 | Test the hall effect sensor signal circuit for an open or short to ground. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | Go to Step 14 | Go to Step 12 |
11 | Test the swivel motor control circuits for an open or high resistance. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | Go to Step 14 | Go to Step 12 |
12 | Replace the mobility seat control module. Refer to Sit-N-Lift Control Module Replacement . Is the repair complete? | Go to Step 14 | -- |
13 | Replace the mobility seat base unit. Refer to Sit-N-Lift Seat Base Replacement . Is the repair complete? | Go to Step 14 | -- |
14 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 3 |