Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provide an overview of each diagnostic category. |
DTC Descriptor
DTC B1259: Antenna Ground CircuitDiagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
B+ Voltage | -- | 1 | -- | -- |
Ground | -- | 1 | -- | -- |
Left Audio Signal (+) | 2 | 2 | 2 | -- |
Right Audio Signal (+) | 3 | 3 | 3 | -- |
Audio Common Signal (-) | 4 | 4 | 4 | -- |
Digital Radio Antenna Coax | B1259 | B1259 | B1259 | -- |
1. No communication with DRR/XM not available 2. No or distorted audio from left side speakers when listening to digital radio 3. No or distorted audio from right side speakers when listening to digital radio 4. No or distorted audio from all speakers when listening to digital radio | ||||
Circuit/System Description
The digital radio receiver (DRR) receives an XM satellite radio signal via the digital radio antenna. This signal is passed to the DRR through the digital radio antenna coax. The DRR sends a varying AC mV signal through separate left and right audio circuits (+ and -) to the radio. The voltage amount and rate of change is dependent upon the type of signal being received. The radio then processes these signals and passes the audio to the appropriate speakers or amplifier.
Diagnostic Aids
When diagnosing digital radio concerns, the vehicle should be located outside with an unobstructed view of the southern sky to ensure proper reception of the satellite signal. Reception may limited, intermittent or not possible inside structures or under heavy cover.
Conditions for Running the DTC
| • | The radio is ON. |
| • | Battery voltage must be between 9-16 volts. |
Conditions for Setting the DTC
The DTC will set when the DRR detects a short to voltage, short to ground, or an open/high resistance in the antenna ground circuit.
Actions Taken When the DTC Sets
| • | Digital radio reception may be poor or not available. |
| • | The radio displays "No XM Signal" or "Check Antenna". |
Conditions for Clearing the DTC
| • | The condition responsible for setting the DTC no longer exists. |
| • | A history DTC will clear once 100 consecutive malfunction-free ignition cycles have occurred. |
Reference Information
Schematic Reference
Radio/Navigation System Schematics
Connector End View Reference
Entertainment/Communication Connector End Views
Description and Operation
Radio/Audio System Description and Operation
Electrical Information Reference
Special Tools Required
EL-48028 Digital Radio Test Antenna
Circuit/System Testing
- Ignition OFF, disconnect the antenna coax from the DRR. Connect the EL-48028 to the DRR.
- Radio ON, tuned to XM, verify DTC B1259 is not set as current.
- Ignition OFF, reconnect the antenna coax to the DRR, disconnect the digital radio antenna coax from the digital radio antenna.
- Ignition ON, test for 4.5-5.5 volts between the antenna coax center terminal and the coax outer shield.
- If all circuits test normal, replace the digital radio antenna.
| ⇒ | If the DTC is current, replace the DRR. |
| ⇒ | If not within the specified range, replace the antenna coax. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
| • | Control Module References for DRR replacement, setup, and programming |
