GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Saturn 🢒 2007 🢒 RELAY 🢒 Body Hardware and Trim 🢒 Interior Trim and Paneling 🢒 Rear Side Door Water Deflector Replacement

Removal Procedure

    Important: By removing the power sliding door (PSD) 15A fuse, the low current logic power for both the LH and RH power sliding door modules (PSDM) will be interrupted and both PSDs will be inoperative.

  1. If equipped with a power sliding door, disable the PSD system by removing the PSD 15A fuse from the instrument panel (I/P) fuse block.
  2. Remove the sliding door inner trim panel. Refer to Rear Side Door Trim Panel Replacement .

    3. Object Number: 319950 Size: SH
  3. Remove the sliding door water deflector from the sliding inner door.

Installation Procedure

    Object Number: 319950 Size: SH
  1. Position the sliding door water deflector to the sliding inner door.
  2. Press the sliding door water deflector onto the sliding inner door in order to wet-out the butyl tape seal.
  3. Install the sliding door inner trim panel. Refer to Rear Side Door Trim Panel Replacement .

    4. Important: By installing the 15A fuse, the low current logic power will be restored to both the LH and RH PSDMs and the PSDs will be operational. However, both PSDMs will have to learn the full open and full closed positions of the PSD. Refer to Rear Side Door Actuator Control Module Programming and Setup .

  4. If equipped with a power sliding door, enable the PSD system by installing the PSD 15A fuse into the I/P fuse block.