GM Service Manual Online
For 1990-2009 cars only

Door Body Side Molding Replacement Front

Tools Required

J 25070 Heat Gun

Removal Procedure


    Object Number: 441631  Size: SH
  1. Use J 25070 152 mm (6 in) from the surface to heat the lower edge of the front door molding.
  2. Use a circular motion for 30 seconds when applying the heat.

    Notice: Refer to Exterior Trim Emblem Removal Notice in the Preface section.

  3. Use a plastic flat-bladed tool to remove the lower edge of the molding from the surface.
  4. Pull the lower edge of the molding out to release the adhesive tape and locating pins.
  5. Pull the lower edge of the molding up to release the molding from the door.
  6. Remove the molding from the door body side.
  7. Use oil-free naphtha or alcohol to clean all traces of adhesive from the body panel.
  8. Dry the surface thoroughly.

Installation Procedure


    Object Number: 1480000  Size: SH
  1. Use a J 25070 to warm the door to a minimum of 21°C (70°F), if necessary.
  2. Insert the alignment pins (3) into the holes, starting at the rear (3) first.
  3. Important: 

       • Do NOT touch the exposed adhesive tape with your hands.
       • Do NOT allow the exposed adhesive tape to collect any dirt or foreign material.

  4. Remove the protective liner (1) from the back side of the molding (2).
  5. Position the retainers at the front and rear edges of the molding.
  6. Press the molding firmly in order to wet-out the adhesive tape.

Door Body Side Molding Replacement Rear

Tools Required

J 25070 Heat Gun

Removal Procedure


    Object Number: 441629  Size: SH
  1. Use J 25070 152 mm (6 in) from the surface to heat the lower edge of the sliding door molding.
  2. Use a circular motion for 30 seconds when applying the heat.

    Notice: Use a plastic, flat-bladed tool to prevent paint damage when removing an emblem/name plate.

  3. Use a plastic flat-bladed tool to remove the lower edge of the molding from the surface.
  4. Pull the lower edge of the molding out to release the adhesive tape and locating pins.
  5. Pull the lower edge of the molding up to release the molding from the door.
  6. Remove the molding from the door.
  7. Use oil-free naphtha or alcohol to clean all traces of adhesive from the body panel.
  8. Dry the surface thoroughly.

Installation Procedure


    Object Number: 1480001  Size: SH
  1. Use a J 25070 to warm the door to a minimum of 21°C (70°F), if necessary.
  2. Insert the rear alignment pins (3) into the holes starting at the rear.
  3. Important: 

       • DO NOT touch the exposed adhesive tape with your hands.
       • DO NOT allow the exposed adhesive tape to collect any dirt or foreign material.

  4. Remove the protective liner (1) from the back side of the molding (2).
  5. Press the molding firmly in order to wet-out the adhesive tape.
  6. Push in the retainers at the front and rear edges of the molding.