GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 25070 Heat Gun

Removal Procedure

  1. When replacing or repairing an emblem/nameplate perform the following:
  2. 1.1. Use tape to protect the body panel during removal.
    1.2. Use tape for alignment marks for installation of the emblem/nameplate.
  3. To remove an emblem/nameplate, heat the emblem/nameplate using a J 25070 .
  4. Apply heat using a circular motion for about 30 seconds holding the J 25070 approximately 152 mm (6 in) from the surface.
  5. Notice: Refer to Exterior Trim Emblem Removal Notice in the Preface section.


    Object Number: 321645  Size: SH
  6. Use a plastic, flat-bladed tool to remove the emblem/nameplate from the panel surface.
  7. When replacing, remove all adhesive as follows:
  8. • For body panels use a 3M™ Scotch Brite molding adhesive remover disk 3M™ P/N 07501 or equivalent.
    • For plastic panels use a lint free cloth and Varnish Makers and Painters (VMP) naphtha or a 50/50 mixture by volume of isopropyl alcohol and water to remove the adhesive.

Installation Procedure

    Important: Apply the emblem/nameplate in an environment that is free from dust or other dirt that could come into contact with the sticky backing. Foreign material may cause improper adhesion.

  1. Clean the area where the emblem/nameplate will be installed.
  2. Use a lint free cloth and Varnish Makers and Painters (VMP) naphtha or a 50/50 mixture by volume of isopropyl alcohol and water to clean the area.

  3. Dry the area thoroughly.
  4. If the location of the emblem/nameplate has not been marked, apply tape and mark the location as shown below.

  5. Object Number: 1502983  Size: SH
  6. For the RELAY (3) emblem/nameplate, install as shown.
  7. • Dimension (a) is 31 mm (1.30 in) from the outer edge of the liftgate to the left side of the RELAY emblem/nameplate edge.
    • Dimension (b) is 209 mm (8.23 in) from the bottom edge of the liftgate to the bottom of the RELAY emblem/nameplate.
    • For the VERSATRAK emblem/nameplate, dimension (c) is 37 mm (1.46 in) from the right edge of the liftgate to the edge of the VERSATRAK emblem/nameplate.
    • Dimension (d) is 53 mm (2.09 in) from the bottom edge of the liftgate to the bottom edge of the VERSATRAK emblem/nameplate.
  8. Heat the mounting surface to approximately 27-41°C (80-105°F) using the J 25070 , if necessary.
  9. Ensure that the temperature of the emblem/nameplate is approximately 29-32°C (85-90°F).
  10. Important: Do not touch the adhesive backing on the emblem/nameplate.

  11. Remove the protective liner from the back of the emblem/nameplate.
  12. Position the emblem/nameplate to the location marks and press the emblem/nameplate to the mounting surface.
  13. Apply equal pressure along the emblem/nameplate to uniformly bond the item to the mounting surface.
  14. Remove the protective tape from the body panel.