- Install the lower intake manifold gaskets.
- Coat the ends of the push rods using prelube P/N 12345501 or the equivalent.
- Install the push rods in their original location.
- Coat the rocker arm friction surfaces using prelube P/N 12345501 or the equivalent.
- Install the valve rocker arms in their original positions.
- Install the valve rocker arm bolts.
Important: All gasket mating surfaces must be free of oil and foreign material. Use P/N 12378392 or equivalent to clean surfaces.
Important: RTV sealer is not to be placed under the lower intake manifold gaskets.
Important: The intake valve push rods measure 146.0 mm (5.75 in) and the exhaust valve push rods measure 152.5 mm (6.0 in) in length.
Important: Shims may be required under the valve rocker arm pedestals if reconditioning has been performed on the cylinder head or its components.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the valve rocker arm bolts to 32 N·m
(24 lb ft).
