Removal Procedure
- Remove the air cleaner inlet duct. Refer
to
Air Cleaner Inlet Duct Replacement
.
- Disconnect the electrical connector (1) from the exhaust gas recirculation (EGR)
valve (2).
- Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle
.
- Remove the transaxle fill tube bolt to the transaxle case.
- Remove the transaxle fill tube nut at the EGR valve and reposition the
fill tube.
- Lower the vehicle.
- Remove the EGR pipe bolt and carefully pull
the pipe assembly back.
- Remove the EGR valve bolts.
- Remove EGR valve.
- Remove the EGR valve gasket.
- Clean and inspect the EGR valve gasket mating surfaces.
Installation Procedure
- Install a new EGR valve gasket.
- Install the EGR valve.
Notice: Refer to Fastener Notice in the Preface section.
- Install the EGR valve bolts.
Tighten
Tighten the bolt to 30 N·m (22 lb ft).
- Install the EGR pipe to the EGR valve.
- Install the EGR pipe .
Tighten
Tighten the bolt to 25 N·m (18 lb ft).
- Connect the electrical connector (1)
to the EGR valve (2).
- Raise the vehicle.
- Position the transaxle fill tube to the normal installed position and
install the fill tube nut at the EGR valve.
Tighten
Tighten the nut to 113 N·m (115 lb in).
- Install the transaxle fill tube bolt to the transaxle case.
Tighten
Tighten the bolt to 113 N·m (115 lb in).
- Lower the vehicle.
- Install the air cleaner inlet duct. Refer to
Air Cleaner Inlet Duct Replacement
.