Tools Required

J 25070 Heat Gun

1. Remove the screws from the rear quarter molding.



2. Use J 25070 152 mm (6 in) from the surface in order to heat the lower quarter molding. Use a circular motion for 30 seconds when applying heat.

Notice: Use a plastic, flat-bladed tool to prevent paint damage when removing an emblem/name plate.

3. Use a flat-bladed tool in order to remove the quarter molding from the surface.
4. Pull the lower quarter molding out, in order to release the retainers.
5. Pull the lower quarter molding out, in order to release from the lower locating pins.
6. Pull the quarter molding up, in order to release from the upper support.
7. Remove the quarter molding from the quarter panel.



8. Pull out the center pins of the support retainers.



9. Use J 25070 152 mm (6 in) from the surface in order to heat the lower quarter molding. Use a circular motion for 30 seconds when applying heat.

Notice: Use a plastic, flat-bladed tool to prevent paint damage when removing an emblem/name plate.

10. Use a flat-bladed tool in order to remove the quarter molding from the surface.
11. Remove the quarter molding support from the quarter panel.
12. Use oil-free naphtha or alcohol in order to clean the body panel.
13. Remove all traces of adhesive from the body panel.

Important: 

•	Do NOT touch the exposed adhesive tape with your hands.

•	Do NOT allow the exposed adhesive tape collect any dirt or foreign material.

1. Remove the protective liner from the back side of the support.
2. Use a heat lamp or heat gun in order to warm the door to a minimum of 21°C (70°F).



3. Starting with the front hole, insert the support retainers into the holes.
4. Press in the support in order to ensure a maximum bond to the quarter panel.
5. Press in the center pins of the retainers.
6. Use a heat lamp or heat gun in order to warm the door to a minimum of 21°C (70°F).



7. Install the quarter molding to the quarter panel.



8. Press the center flange of the quarter molding into the 2 outer retainers.
9. Press the locating pins into the holes of the quarter panel.
10. Press the center flange of the quarter molding into the remainder of the retainers on the quarter panel.
11. Push the upper portion of the quarter molding inboard over the retainers.

Important: Do NOT touch the adhesive backing.

12. Remove the protective liner from the back side of the quarter molding.
13. Press the bottom of the quarter molding inboard in order to ensure a maximum bond to the quarter panel.

Notice: Refer to Fastener Notice in the Preface section.

14. Install the screws to the rear quarter molding.

Tighten
Tighten the screws to 2 N·m (18 lb in).