The power sliding door module (PSDM) can detect when the clutch assembly cable is not connected. A disconnected or broken cable, cable bracket or a cable fastener are the only events which can cause the DTC to be set. Except for the serial data communications circuits, no electrical circuits are involved in the setting of this DTC.
A power sliding door close function is attempted.
The PSDM has detected that the power sliding door motor and clutch assembly cable is no longer connected.
All further power operation is inhibited.
• | The DTC will be current for as long as the cable failure is present. |
• | When the failed cable assembly has been replaced, the DTC will be cleared due to PSDM being unpugged or power disconnected. |
Power Door Systems Connector End Views
Power Sliding Door (PSD) Description and Operation
⇒ | Inspect the cable assembly on the power sliding door. If the cable assembly is broken, replace the cable assembly. |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.