The body control module (BCM) receives a signal from the brake pedal position sensor through the brake pedal position sensor signal circuit. The BCM then applies voltage through the stop lamp supply voltage circuit to the powertrain control module (PCM) or engine control module (ECM), electronic brake control module (EBCM), and the stop lamps.
This diagnostic procedure supports the following DTC:
DTC P0572 Cruise Control Brake Pedal Position Sensor Circuit Low Voltage
• | The vehicle has cycled from 0-60 km/h (0-37 mph) 3 times in one ignition cycle. |
• | Continuous once the previous criteria have been met. |
The PCM/ECM detects low voltage on the stop lamp supply voltage circuit when the circuit should be battery positive voltage.
• | The PCM/ECM stores the DTC information into memory when the diagnostic runs and fails. |
• | The malfunction indicator lamp (MIL) will not illuminate. |
• | The PCM/ECM records the operating conditions at the time the diagnostic fails. The PCM/ECM stores this information in the Failure Records. |
• | A last test failed, or current DTC, clears when the diagnostic runs and does not fail. |
• | A history DTC will clear after 40 consecutive warm-up cycles, if no failures are reported by this or any other non-emission related diagnostic. |
• | Use a scan tool in order to clear the DTC. |
• | Verify that the brake pedal position sensor is adjusted properly. Refer to Brake Pedal Position Sensor Calibration . |
• | Test drive the vehicle if a switch or circuit condition cannot be located. An intermittent condition may be duplicated during a test drive. |
• | For an intermittent, refer to Testing for Intermittent Conditions and Poor Connections . |
The number below refers to the step number on the diagnostic table.
Step | Action | Yes | No |
---|---|---|---|
Schematic Reference: Exterior Lights Schematics Connector End View Reference: Master Electrical Component List | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |
Does the stop lamp signal parameter indicate ON? | Go to Step 3 | Go to Diagnostic Aids | |
3 | Test for a short to ground or an open in the stop lamp supply voltage circuit. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | Go to Step 5 | Go to Step 4 |
4 | Replace the body control module (BCM). Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement? | Go to Step 5 | -- |
5 |
Does the DTC reset? | Go to Step 2 | System OK |