Steering Knuckle Replacement. Saturn SKY 2007

For 1990-2009 cars only

Makes 🢒 Saturn 🢒 2007 🢒 SKY 🢒 Suspension 🢒 Tires and Wheels 🢒 Steering Knuckle Replacement

Callout

Component Name

Notice: The ball stud must not rotate during disassembly or reassembly. Hand tools must be used to keep the ball stud from rotating. If air tools are used and the stud is allowed to rotate, damage to the ball stud and/or stud mounting hole may occur.

Preliminary Procedure

Remove wheel hub and bearing assembly. Refer to Wheel Hub/Speed Sensor Replacement .

Outer Tie Rod End Retaining Nut

Notice: Refer to Fastener Notice in the Preface section.

Tip
Using the J-42188-B Ball Joint Separator, separate the outer tie rod end from the steering knuckle. Do Not loosen the adjustment jamb nut. Refer to Rack and Pinion Outer Tie Rod End Replacement .

Tighten
30 N·m (22 lb ft) plus an additional 115°

Upper Ball Joint Retaining Nut

Tip

•	Loosen but DO NOT remove the nut until the ball stud has been separated from the knuckle.

•	Using the J-42188-B , separate the ball stud from the knuckle.

Tighten
30 N·m (22 lb ft) ± 150°

Lower Ball Joint Retaining Nut

Tip

•	Rotate the forward edge of the knuckle outboard to provide access for the J-42188-B .

•	Loosen but DO NOT remove the nut until the ball stud has been separated from the knuckle.

•	Using the J-42188-B , separate the ball stud from the steering knuckle.

Tighten
40 N·m (30 lb ft) ± 135°

Steering Knuckle