Removal Procedure
- Remove the rear differential. Refer to
Differential Replacement
.
- Remove the 9 carrier cover bolts (6).
- Using the pry tabs (4, 5, 7), remove the carrier cover (3) from the differential carrier (1).
- Remove the O-ring seal (2) from the cover (3).
Installation Procedure
- Install the housing cover O-ring (2) into the groove on the housing cover (3).
- Apply a light coat of oil to the housing cover O-ring (2) and install the housing cover (3) onto the housing (1).
Notice: Refer to Fastener Notice in the Preface section.
- Install the 9 side cover bolts (4).
Tighten
Tighten the 9 side cover bolts in a criss-cross pattern to 29 N·m (21 lb ft).
- Install the rear differential. Refer to
Differential Replacement
.