Observe the clutch spin down time as follows:

1. Apply the parking brake. Block the vehicle wheels.
2. Shift the manual transmission into NEUTRAL.
3. Start the engine. Run the engine at idle speed.
4. Engage the clutch.
5. Disengage the clutch. Wait 9 seconds.
6. Shift the transmission into REVERSE.

The clutch driving members are 2 flat surfaces machined to a smooth finish. They include:

The driven member is the clutch driven plate. The clutch driven plate has a splined hub. The splined hub slides lengthwise along the splines of the input shaft. The splined hub drives the input shaft through these same splines. The driving and driven members are held together with a spring pressure. This pressure is exerted by a diaphragm spring in the clutch cover.

Notice: Do not use mineral or paraffin-base oil in the clutch hydraulic system. These fluids may damage the rubber parts in the cylinders.

The clutch system consists of the following components:

With the depression of the clutch pedal, the clutch master cylinder becomes pressurized from the force of the push rod into the master cylinder. This forces hydraulic fluid into the tubing from the master cylinder to the actuator cylinder. The actuator cylinder then pushes the release bearing into the diaphragm spring to disengage the clutch. A hole in the cowl panel accommodates the master cylinder. A quick connect coupling helps route the hydraulic tubing. The actuator cylinder is inside the transmission and on the input bearing retainer. The clutch master cylinder can be replaced as an individual component by disengaging the quick connect coupling and removing the push rod from the clutch pedal. No adjustments to the clutch system are necessary. As the clutch wears, the fluid level in the brake master cylinder reservoir changes to compensate for clutch wear. A new system will have fluid at the maximum level in the reservoir. The electrical switches on the clutch pedal bracket have 2 functions. 1 function is a clutch interlock, ensuring the engine does not start unless the clutch pedal is positioned to the floor. The second function is to cut off the cruise-control system, if equipped, when the clutch pedal is depressed.