Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC P0560: System VoltageDiagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
Ignition 1 Signal | P0560 | P0560 | -- | -- |
Circuit/System Description
The engine control module (ECM) monitors the system voltage to ensure that the voltage stays within the proper range. Damage to components and incorrect data may occur when the voltage is out of range.
Conditions for Running the DTC
| • | The vehicle speed is below 40 km/h (25 mph). |
| • | The system voltage is below 11 volts or above 16 volts. |
| • | Engine speed is above 1,500 RPM. |
Conditions for Setting the DTC
The ECM detects a system voltage out of range for 2 seconds.
Action Taken When the DTC Sets
| • | The ECM will command the charge indicator and or warning message to be illuminated on the instrument panel cluster (IPC) and the driver information center (DIC), if equipped. |
| • | The ECM will not illuminate the malfunction indicator lamp (MIL). |
| • | The ECM will store conditions, which were present when the DTC set as Fail Records data only. |
Conditions for Clearing the DTC
| • | The ECM will command the message OFF after one trip in which the diagnostic test has been run and passed. |
| • | The history DTC will clear after 40 consecutive warm-up cycles have occurred without a malfunction. |
Reference Information
Schematic Reference
Starting and Charging Schematics
Connector End View Reference
Engine Electrical Connector End Views
Description and Operation
Charging System Description and Operation
Electrical Information Reference
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions
Scan Tool Reference
Circuit/System Verification
With the scan tool installed, engine running, observe the ECM Ignition 1 signal parameter in the ECM data list. The ignition 1 signal parameter should read between 11.5 volts - 15.5 volts.
Circuit/System Testing
- Measure the voltage at the battery terminals and compare it with the Ignition 1 signal parameter. Verify that battery and Ignition 1 signal readings do not differ more than 0.8 volt.
- Go to Charging System Test .
| ⇒ | If more than the specified value, test the Ignition 1 and ground circuits of the ECM for an open, high resistance or replace the ECM. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for ECM replacement, setup, and programming
